Professor
Email: xmhuang@hust.edu.cn
Academic Areas: Engineering Thermophysics
Academic Interests: Heat transfer and fluid flow in porous media, Gas-liquid Two Phase Flow and Heat Transfer, Enhancement Heat Transfer Technologies in Energy Power Equipment, Thermodynamics Analysis of Energy System, Heat and Fluid flow in Devices of NPP, Theoretical Prediction of the Sealing Characteristics of the NPP Containment
Academic Degrees
PhD, 2004, School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan China;
Bachelor, 1998, School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan, China.
Professional Experience
Professor (2021-present); School of Energy and Power Engineering, Huazhong University of Science and Technology;
Associate Professor (2006-2020); School of Energy and Power Engineering, Huazhong University of Science and Technology;
Lecturer (1998-2005); School of Energy and Power Engineering, Huazhong University of Science and Technology.
Selected Publications
· X.M. Huang et al, “A thermal cloak with thermoelectric devices to manipulate a temperature field within a wide range of conductivity ratios”, J. Phys. D: Appl. Phys, 2020, 53, 115502
· G. Xu, X.M.Huang(*) et al. “Effects of thermal and electrical contact resistances on the performance of a multi-couple thermoelectric cooler with non-ideal heat dissipation”, Applied Thermal Engineering 2020, (169), 114933
· Huang, X.M., Shi C.Y., Zhou J., Lu X., Xu G. L. (*), “Performance analysis and design optimization of heat pipe sink with a variable height fin array under natural convection”, Applied Thermal Engineering, 2019, (159), 113939
· Xu G.L., Du Y, Huang, X.M. (*), “Numerical analysis of gas tightness of seals in pSOFCs based on Lattice Boltzmann Method simulation”, International Journal of Hydrogen Energy, 2019, 44(38),21136-2114
· Huang X.M., Sun J, Xu G*, et al. “Fractal analysis of the penetration flow through micro-nano porous gaskets with effects of slippage and stress-sensitivity”. Fractals, 2018,27(3),1950031.
· Huang X, Yang W, Ming T, et al. “Heat transfer enhancement on a microchannel heat sink with impinging jets and dimples”. International Journal of Heat & Mass Transfer, 2017, 112:113-124.
· Gong T, Ming T(*), Huang X(*), de Richter RK, Wu Y, Liu W. “Numerical analysis on a solar chimney with an inverted U-type cooling tower to mitigate urban air pollution”. Solar Energy. 2017;147(Supplement C):68-82.
· Ming T, Yang W, Huang X, et al. “Analytical and numerical investigation on a new compact thermoelectric generator”. Energy Conversion & Management, 2017, 132:261-271.
· Ming T, Yang W, Wu Y, et al. “Numerical analysis on the thermal behavior of a segmented thermoelectric generator”. International Journal of Hydrogen Energy, 2016, 42(5), 2017, 3521-3535
· Deng C, Yu X, Yang, N. *, Huang X*, et al. Enhancement of interfacial thermal conductance of SiC by overlapped carbon nanotubes and intertube atoms[J]. Journal of Heat Transfer, 2016, 139: 054504-1-3
· Huang, X.M. and Xu, G.L. (2016). " Study on leakage rate of rubber sealing structures based on percolation theory ". ASME. IMECE2016, Volume 6B: Energy, V06BT08A033, November 11–17, 2016: IMECE2016-66093
· Huang, X.M., Shang W.L., Zhu X.M. (2016). " Three-dimensional heat and mass transfer analysis in disk evaporator of loop heat pipe". Journal of Thermal Science and Techanology, 2016,03:179 -184.
· Dai X.C., Huang, X.M., Liu W.(2016). " Simulation Research of the Dynamic Behavior of the Plate Heat Exchanger for the Waste Heat Recovery Application". Energy conservation technology, 2016,03:179 -184.
· Mi, X. Y., Yu, X., Yao, K. L., Huang, X., Yang, N., & Lü, J. T. (2015) "Enhancing the thermoelectric figure of merit by low-dimensional electrical transport in phonon-glass crystals", Nano Letters, 2015, 15(8), 5229-5234.
· Fang H.S., Lin J.Z., Zheng L.L. *, Huang X.M. *, (2015) "Analysis and Optimization of Czochralski Laser Oxide Crystal Growth ". International Journal of Heat and Mass Transfer, 2015, 85: 505-512
· Long R., Bao Y.J., Huang X.M. *, Liu W. *, (2014)" Exergy analysis and working fluid selection of organic Rankine cycle for low grade waste heat recovery", Energy, 2014, 73(14):475-483
· Fang T., Ming T.Z., Tao C.P., Huang X.M.,(2014) "Analysis of non-uniform heat loads on evaporators with loop heat pipes", Int. J. Heat and Mass Transfer, 2014, 75(8):313-326
· Huang, X.M. and Jin X..(2013) "Analysis of vapor blanket formation in the porous wick of a loop heat pipe with high heat load", Proceedings of the ASME 2013 IMECE, 2013, USA
· Fang H.S., Jin Z.L., Huang X.M.，(2012)"Study and optimization of gas flow and temperature distribution in a Czochralski configuration"，Journal of Crystal Growth, 2012, 361(15 ):114-120
· Huang, X.M., Yu B.M.,(2013) "Effects of Heat And Mass Transfer of Thin Film Region on the Stability of the Capillary Evaporating Meniscus", Journal of Astronautics, 2013, 34(6):873-880
· Huang, X.M., Yu B.M.,(2013)"Numerical analysis of variation of capillary evaporating meniscus profile with different operating condition", Journal of Thermal Science and Techanology, 2013,12(2): 102-106
· Huang, X.M., Jin X.,(2013)" Effect of working fluid on heat transfer of evaporating on heat transfer of evaporating extended meniscus in capillarty channel", Journal of Aerospace Power, 2013,28(12): 2703-2708
· Huang, X.M., Jin X.,(2013)" Effects of thermophysical properties of working material on heat and mass transfer of evaporating capillary meniscus", J. Huazhong Univ. of Sci. and Tech.(Natural Science Edition), 2013, 41(4): 98-102
· Huang X.M., Shi K., Huang X. (2011), "Optimal Design of Heat Pipe Based on the Multi-object Genetic Algorithm, Journal of Refrigeration", 2011, 32(2):14-18,
· Huang X.M., Kaya T.( 2010), "A linear stability analysis based explicit stability criterion of capillary evaporating meniscus", Journal of Astronautics, 2010, 31(5):
· Huang X.M., Kaya T.(2010), "Heat and mass transfer characteristics and stability of capillary evaporating meniscus", Journal of XI’AN Jiaotong University, 2010, 44(3),
· Huang X.M., Liu W., Nakayama A.(2005), "Modeling for heat and mass transfer with phase change in porous wick of CPL evaporator", Heat and Mass Transfer, 2005, 41: 667-673
· Huang X.M., Liu W.(2005), "A mathematical model for analyze heat and mass transfer characteristic of porous wick of CPL evaporator", Heat Transfer- Asian Research, 2005, 34(4): 209-218
· Huang X.M., Liu W.(2004), "A new model for the heat and mass transfer character of CPL evaporation", Journal of Engineering Thermophysics, 2004, 25, 652~654, , Vol25, No.4
Awards:
2017 University Teaching Quality Prize (First prize), Huazhong University of Science and Technology.
2012 University Excellent Teaching Prize (First prize), Huazhong University of Science and Technology.
2006 University Excellent Teaching Prize (First prize), Huazhong University of Science and Technology.
Courses Taught
Engineering Thermodynamics (BA course)
Heat Transfer (BA course)
Heat and Mass Transfer Theory in Porous Media (MS course)
Projects
1. National Natural Science Foundation of China: 51576077, “Research of fractal theory and leakage mechanism in the tightness structure of the reactor containment”, January 1, 2016 to December 31, 2019.
2. National Natural Science Foundation of China (Project No. 51106057), “Research of the interface oscillation and its stability mechanism in capillary phase change loop”, January 1, 2012 to December 31, 2014.
3. Crosswise Project Supported by China Ship Development and Design Center, " Theory and Simulation Experiment Study on leakage mechanism of pressure vessel ", Sep 2014 to Sep 2016.
4. Scientific Research Foundation for the Returned Overseas Chinese Scholars, "Study of interface stability of heated and evaporating capillary meniscus and its influence on the capillary phase change loop system”, April 2011 to April 2012
5. Postdoctoral Sustentation Fund of China (Project No. 20070420903), “Research of the interface oscillation and its stability mechanism in capillary phase change loop”, January 1, 2012 to December 31, 2014.
